Marking of non-selected enemies only on mouseover

There is 1 reply in this Thread. The last Post () by SWAT_OP-R8R.

  • Hello,

    Today i started crossfire 2.0.1 SP campaign and i noticed, that all ships (except the one i have selected atm) don't have those small border markings, which I have been used to from Vanilla Freelancer.

    Those markings show only when i mouseover the ship (you can see in the attached screenshots).

    I cannot find any settings for that particular case.


    Is there a way to enable them, so they show always, as in Vanilla Freelancer? ... I mean some .ini or .dll file, where it can be changed.

    Thanks in advance. :)

  • nope



    Only dead fish swim with the stream.
    Don't discuss with idiots. They only drag you down to their level and then beat you with experience there.

    This is ten percent luck,
    Twenty percent skill,
    Fifteen percent concentrated power of will,
    Five percent pleasure,
    Fifty percent pain,
    And a hundred percent reason to remember the name!