Search Results

In picture below is config made for my Thrustmaster T.16000M. Using both hands on it, on keyboard only some minor importance keys. Still experiment how (or if) to set it better, but if I used for some movements in assist off it worked not bad ... dunno, matter of "get used" to your chosen setup. But is fact that especially 2nd fire usage is not easy.

Thinking about Gametrix ECS throttle ... there was some issue with it on ED, but previous week was info on frontier forum that new firmware resolved it use in ED (something about differently named axis which were not recognized by game). With all these additional buttons should be not problem map all needed keys. Elite still dont see my throttle

I reconsidered few times further HW investments, and in the end changed my mind and fully reworked my controllers setups using OPs advice in 1st post. Especially main thrusters fw and back on joy buttons and secondary fire on keyboard (space) + power distribution works significantly better than i had before (and is also much easier to remember these settings). Except some slight changes I added on Tab key "assist off" because I use this feature quite often. Joystick and keyboard offers quite goo…

THRUSTMASTER TEAMS UP WITH FRONTIER’S ELITE DANGEROUS: NEW GAMEPLAY EXPERIENCES ANNOUNCED – NEW T.16000M FCS HOTAS | Thrustmaster This is not very costly hardware and I hope will have it in few weeks.

Finally that item arrived (more as 2 weeks delayed) and I like how it fit into my hands. Except circuit axe controller on left side (thruster) I have all buttons used and it need only more practising to use it fully smoothly. First time feelings are really good. I can recommend use also target software (thrustmaster official): you can easily adjust axis response curves, set dead zones and map keyboard keys to buttons. I have set thruster to full range (-32k to +32k) with dead zone (thruster do n…