I am using:
Windows 7 – 64bit
Q9300 2.5ghz CPU
8GB RAM
Geforce GTX 450
So after numerous attempts over the past 3 days of trying to get Crossfire 1.9 to work, almost ready to give up so this is my last attempt. Each time the problem has been what is in the subject. I have checked the threads that are similar and nothing has worked. I have followed a few different sets of instructions from different people to no avail.
The first time I tried Norton complained at me and quarantined a file which I quickly restored the file and set the correct instruction for Norton to allow the file. I had problems running it still so tried a re-install which then gave me the 0xc0000005 error. I wasn't able to actually start the game on both occasions though.
The last attempt I have just tried:
1. Installed Freelancer – deleted save file
2. Un-ticked read only
3. Installed flmm 1.31 (unblocked exe file first)
4. Un-ticked read only
5. Installed Crossfire(unblocked exe first) to flmm mods file
6. Turned off read only for flmm & freelancer again
7. Ran Freelancer – Opened Crossfire Launcher http://tinypic.com/r/29bknx2/8
8. Waited for download of client and then clicked on single player
9. Computer tried to load game for a few second, nothing happened
10. Tried to run Freelancer.exe again, client crashes and then opens different launcher http://tinypic.com/r/wqt3bo/8 http://tinypic.com/r/2808n5c/8
11. Clicked on Single player and receive error; “Application popup: Freelancer.exe - Application Error : The application was unable to start correctly (0xc0000005). Click OK to close the application.”
No problems from Norton Anti Virus
Used Administrator privileges as much as possible
No problems mentioned during installation of Crossfire1.9 or flmm 1.31
Used CCleaner/ revo to get rid of all FL/ FLMM/ Crossfire related data before attempting install
Tried setting Freelancer.exe as compatibility mode – windows xp
No Windows updates recently
Also tried downloading CF1.9 and FLMM all over again just incase they were corrupted.
Looked in my event
viewer for Application errors:
EVENT ID: 1001
[font='"']Fault bucket
, type 0[/font]
Event Name: PCA2
Response: Not available
Cab Id: 0
Problem signature:
P1: Freelancer.exe
P2: 0.9.0.8
P3: CFLauncher
P4: CFLauncher
P5: utrack
P6: 200
P7: -1
P8:
P9:
P10:
I’ve also tried on previous attempts:
1) install vanilla FL (remove from whole folder write protection and made COPY for this vanilla FL folder to separate place (will explain later)
2) install FLMM
2a (optional) reboot PC
3) install CF (it will ask for flmm location and will instal into
flmm/mods/crossfire1.9 directory
4) (optional) remove write protection from this installed mod
5) run flmm as administrator! and activate CF
6) (optional) remove write protection from activated CF
7) DELETE previous FL save folder in documents (like I mentioned above)
7b (optional) reboot PC
run cf as admin (is rly good idea run cf via shortcut to freelancer.exe.
Using flmm for run cf is not necessary and very likely only lead to troubles
(as I vitnessed on one my clan mate). For this shortcut you can easily set 'run
as admin' in file properties)
As well as the install instructions in the Q/A as well as from the CFguide.swf
Hopefully able to get some help if possible
Thanks in advance.